Model Railway Forum

I've drawn up a design for a peco pl11 style point motor for surface mounting... looking at the seep style motor... it wouldn't be difficult to redesign mine to allow a seep to be surface mounted... but you'd have to shorten that pin some!

IanS wrote: ↑Wed Feb 17, 2021 4:03 pm https://www.ebay.co.uk/itm/Point-Motor- ... SwoWBgG~N1

This may be what is needed - it is 3D printed - although I've not tried them.

Ian

I am not sure that would work as an above baseboard mount the mounting screws would get in the way of any link. Even the blurb says it is for ease of mounting on the underside.

Richard

I must have misread this - sorry.