Page 1 of 4
Back to the bench
Posted: Sat Jan 12, 2019 8:46 pm
by brian1951
So nice to be back to normal for just a couple of days, while the plaster dries
Re: Back to the bench
Posted: Sat Jan 12, 2019 9:32 pm
by Mountain Goat
I need to clear my layout as it gets used for putting things on. I have a little work planned on it. Actually, I can put the layout up in the barn to paint it. Saves the risk of paint fumes and getting paint on the carpet or clothes.
Looks like you have some projects lined up.
Re: Back to the bench
Posted: Sun Jan 27, 2019 1:25 pm
by brian1951
Re: Back to the bench
Posted: Sun Jan 27, 2019 6:19 pm
by brian1951
Taking advantage of the bad weather i did some more work indoors and tested a few n gauge locos.
Re: Back to the bench
Posted: Fri Feb 01, 2019 12:05 pm
by brian1951
A couple of BLs turned up this morning for there annual service and inspection, give me a change from building
Re: Back to the bench
Posted: Fri Feb 01, 2019 12:58 pm
by Mountain Goat
You must have good eyes to work on N gauge. I thought I was struggling to focus. Recently I believe I have found the cause (Via another more concerning issue caused by an allergy) and my eyes are starting to focus sharply again.
You have quite a production going. Do you get time to breathe?
Re: Back to the bench
Posted: Fri Feb 01, 2019 1:00 pm
by Steve M
The BLs Brian refers to are OO.
Re: Back to the bench
Posted: Fri Feb 01, 2019 1:04 pm
by Walkingthedog
He didn’t say any of the locos worked after he’s serviced them
Re: Back to the bench
Posted: Fri Feb 01, 2019 1:06 pm
by Mountain Goat
Haha. Like Wesley from the Last Of The Summer Wine?
I think he is better then that.
Re: Back to the bench
Posted: Fri Feb 01, 2019 2:05 pm
by brian1951
For anyone who has a BL, its worth removing the smoke generator while you have it stripped down and cleaning it out, check fans are ok reseal and refit. just a tip to keep it clean.
