Model Railway Forum

I think I'm ok with the concept of wiring a double slip (Peco SL-90).

My question is about addressing the point motors. Am I correct in assuming they would have the same address so they would work in unison?

If another point is then attached would that also require the same address?



So would PM1, PM2 & PM3 all be the same?

I can only comment from an analogue perspective based on the one I have. The motors have to act independently to allow the various routes to be selected, therefore I have separate switches for each PM.
I presume under DCC operation it would be the same.

Think of a slip as two separate points and you soon see they must be able to act independently, therefore must be different DCC addtesses

Otherwise you can only set one of two routes.

All above are correct. Two motors on a DS need separate address numbers.

Thanks Guys.
In my diagram would PM3 share an address with either PM1 or PM2 at all as opposing point motors would?

Personally, I would give all three separate address numbers, as PM1 and PM2 can be set to different routes through the DS. I feel trying to work out when PM3 is to be set towards the turnout route would be very complex to do from the DS PM1 and PM2 routes.
Easy with single operations IMO, more easier singerly if your DCC system allows routes (Macros) to be set?

Thanks Brian, that makes sense. It will be used with a Z21 and iTrain both of which can do routes. They can calculate it far quicker than I can

Totally agree with Brian re routes and macros. On my previous layout I had 3 single slips used to join/leave a double track oval to a set of storage sidings. To complicate matters two of these were at the back of the layout out of sight. I found it easier to draw out all the permutations of each slip and assign a macro for each route on my powercab - see attached example.

My biggest problem with slips was getting the frog switching right!