Model Railway Forum

Peco do an isolating track ST-2005 for 00 gauge. Does anyone know if the same is available in n gauge, I can't see anything. If nothing exists can anyone suggest a method to keep 2 locos in an engine siding, with one being isolated. My locos are not fitted with DCC. Any suggestions welcome. Cheers
Dougie B

Either put in an insulated track joiner or cut one rail with a slitting disc in a mini drill.
Soldier wires either side of the cut or joiner and connect them to a simple on/off switch.

Minitrix do this:

https://www.osbornsmodels.com/minitrix- ... 5218-p.asp

Thanks for the replies, both were really helpful. I've not used minitrix track before - is it compatible with Peco track

dougieb1903 wrote: ↑Mon Nov 23, 2020 11:44 am I've not used minitrix track before - is it compatible with Peco track

That is a good question!

I do not think that it 100% compatible, but it can be made to fit. I think the track height and track dimensions are very slightly (0.1mm?) different. For one piece of track it is probably not worth the hassle.

Minitrix is 50mm - Peco N ST-2 short straight is 58mm Those 8mm will cause no end of problems.