Doc tam valley dual juicer

[yelrow]

Hi, have an oblong of track, eg, one roundy roundy, and wish to add a point either sidé, so line crosses about the middle, this will then become return loop, I have the above tam valley, but instructions might as well be in. Chinese, as far too complex for a simple soul. Can a nice kind person tell me how to wire it up, thanks, john. Ps, DCC,

[Brian]

Hi
Assuming you want the Dual Frog Juicer to operate the isolated rails of the reverse loop only. (It cant be used for anything else when used as a RLM!) Then connect the isolated reverse loops rails to the two 'Frog' terminals on the Juicer. Connect to the rails either way around. Connect the DCC bus or feed from the DCC 'Track' terminals that goes to the normal DCC power rails to the two DCC 'Track Bus' connections, again either way around. Set jumper to Reverse Loop operation. Job done.
Note: No other connections should be on the isolated rails of the reverse loop anywhere between entrance IRJ pair and any exit pair of IRJs.

[yelrow]

Thank you, Why could not the long technical blurb that came with it, simply say that, I will get on with installation, Cheers Brian, john.