Page 4 of 10
Re: My layout
Posted: Tue Feb 11, 2020 1:59 pm
by Puddles
Thank you Glencairn
Good advice
Bob
Re: My layout
Posted: Thu Mar 26, 2020 7:53 am
by Puddles
Just made up this little kit
Puddles
Re: My layout
Posted: Thu Mar 26, 2020 8:07 am
by Walkingthedog
Very nice. What make is it?
Re: My layout
Posted: Thu Mar 26, 2020 8:22 am
by teedoubleudee
Puddles wrote: ↑Thu Mar 26, 2020 7:53 am
Just made up this little kit
Puddles
I really like that, well done.
Re: My layout
Posted: Thu Mar 26, 2020 8:42 am
by Puddles
Walkingthedog wrote: ↑Thu Mar 26, 2020 8:07 am
Very nice. What make is it?
I have this kit to do next an,overhead crane.
You can see by the box the water tower/coaling stage is a Ratio trackside series.
These kits go together really well and reasonably priced.
Now the sun is shining lots to do in the garden first.
Puddles

Re: My layout
Posted: Thu Mar 26, 2020 9:49 am
by Walkingthedog
I’ve made lots of Ratio kits. They are excellent. Well I think so.
Re: My layout
Posted: Thu Apr 30, 2020 5:34 pm
by Puddles
Another kit made up
See my post STATION CANOPY on the work bench.
Puddles

Re: My layout
Posted: Sat May 02, 2020 7:58 am
by Puddles
Wish I had read the station canopy assembly instructions more carefully.
I will have to remove the columns and replace them to reduce the width, when the canopy is in place they are to near to the edge of the platform. My little plastic passengers will be stepping of the train and walking straight into a post. Oh well back to the work bench at least I only made up one kit the next one will be spot on.i hope.
They do say you learn from your mistakes, seem to be learning a lot lately

Puddles

Re: My layout
Posted: Sat May 02, 2020 8:20 am
by Walkingthedog
Thought it looked a bit strange but couldn’t put my finger on why.
If all else fails read the instructions.

Re: My layout
Posted: Sat May 02, 2020 8:23 am
by RogerB
Bad luck. It looks as though how you have it could/should be alright, but yes you cannot knock your passengers out
From the image on the Peco website, it looks as though the columns should be in from the edge but flush with the sides. Is that what you need to do?
R-