Page 2 of 2

Re: Bayview Halt Layout F.O.C

Posted: Tue Apr 08, 2025 1:33 pm
by Mountain Goat
That panel controller is interesting. There were many makes in the past which have dissapeared when DCC took over. I very much noticed this and I miss the variety of lovely DC controllers that we used to have.

Re: Bayview Halt Layout F.O.C

Posted: Tue Apr 08, 2025 4:57 pm
by wecpcs
I did intend to add another comment regarding the make of controller as I had remembered what it was, but unfortunately I must have forgotten to press the submit button.
It was actually a Codar controller, but I cannot remember what model number it was. I have searched for Codar controllers and found very simailar ones, but not quite the same, and yes it was a very good DC controller.

Re: Bayview Halt Layout F.O.C

Posted: Fri Jun 27, 2025 10:36 am
by wecpcs
Due to lack of interest Bayview Halt is now sadly dismantled and no longer for sale.

All the points with their point motors have been carefully removed and added as a bulk lot in the For Sale section along with a list of all rolling stock for sale.